When we made our initial prototypes for spiral golf ball we were not completely happy with the process of developing four individual printing moulds applied to the core of the ball to create the 360 degree spiral pattern. Each spiral ball was then completed with a transparent injection moulded dimpled cover.
We our now investigating developing a 2-piece-2-colour injection moulded dimpled cover. This process would allow us to use two separate compounds of material in the cover, instead of the traditional method where a mantle layer is used below the cover to create the required spin / soft feel.
From the picture, the yellow section would be a harder material and the red sections a softer compound to create a 2-piece-2-colour injection moulded dimpled golf ball cover.
‪#‎spiralball‬ ‪#‎twopiecetwocolourcover‬ ‪#‎golfrefugees‬

No comments:

Post a Comment